Install clear corner lights on a 95 integra DC any any suggestions?

just looking for a little advice on how to install new corner lights on my integraInstall clear corner lights on a 95 integra DC any any suggestions?
dont listen to that moron about them being illegal. If they are DOT stamped they are legal, you have to use amber bulbs though. I have never done it on a teg, but they are in the bumper in USDM integras. That makes it a relatively simple process. On the back there should be a couple small bolts holding the whole unit in place... remove those and replace with new corner lights.








If it is JDM, or EDM I have NO idea I believe the headlight and corner light is a single unit.Install clear corner lights on a 95 integra DC any any suggestions?
I agree with the above answer. They arent illegal if they are DOT (department of transportation) approved. BUT as stated, an amber/orange bulb will need to be utilized here. You cannot use blue, white, purple or anything else. These colors are not DOT approved. The process is VERY simple to change the lens out.





There will be ONE screw on each lens (left and right). Remove this screw and the lens will come out at an angle if pull on the side the screw was on. Dont pull it out too much because you still need to remove both bulb sockets before continuing. Both sockets turn a certain way and then come straight out. Once the lens is off, replace with your clear lens and put the sockets back in as you removed them. On one side of the lens will be a little tab that goes in a slot just behind the bumper (you will see it if you look in). Put that tab in the slot and puch in the side where the screw goes. Replace the screw and youre done. Do the other side and your project will be completed. Turn the lights on, and check to make sure the bulbs still work correctly and admire your work. Good luck!
Those are illegal so I hope you get them on so you can get a ticket soon.